Long burning heating furnaces Breneran (Buleryan)

Stoves, boilers, chimneys "
Catalog »
Heating stoves "
Heating stoves Breneran (Buleryan)

Long-burning heating furnaces Breneran (Buleryan) are reliable equipment for uniform heating of premises in private houses and dachas, operating on solid fuels.
The principle of operation of such a furnace is based on air circulation. The Breneran firebox is surrounded by 3-6 pipes on each side. Cold air is blown into them from below, it passes through the heated metal pipes, comes out already warm and is evenly distributed over the heated room. The pipes warm up in 10-15 minutes after kindling, their temperature quickly reaches 100-120 degrees.

Types of heating stoves Buleryan

In the catalogs of the online store R-sauna.ru you will find:

Conventional ovens Breneran. They have one task - uniform heating of the room by convection under conditions of prolonged burning of fuel.
Fireplace type. This is a heating equipment with a glass door. This is a convenient and aesthetic kind of stoves in which you can control the flame without opening the firebox door.
With a water circuit. Heating of premises is carried out by heating the water passing through the circuit or a special liquid for heating systems.
With a hob. An ideal type of stoves for summer cottages, which are not supplied with gas, in this case, Breneran is used for cooking.

In our online store you can buy the ovens themselves and everything you need for their installation, in the catalogs you will also find: special heat-resistant sheets for installing Buleryans, as well as supports and thermal protection.

Gas generator furnace operation

After installing the stove, make sure that the joints of the flue duct are tight and that there is a draft. To do this, a strip of thin paper or a candle flame is brought to the open door of the firebox. Their deviation towards the firebox indicates the presence of traction.

Kiln lighting

Before firing, set the power regulator and the gasifier regulator to the fully open position. Then, using paper and wood chips, melt the oven.

Adjustment

After the fire has flared up, you put the main fuel, trying to fill the volume of the lower chamber as much as possible. AFTER THE MAIN FUEL HAS BEEN BURNED AND THE CHIMNEY PIPE WARMED UP (15 - 20 MINUTES), YOU MUST CLOSE THE GASIFICATOR REGULATOR AT LEAST 45 DEGREES FROM ITS LONGITUDINAL POSITION. This puts the oven into gasification mode. The position of the regulator-gasifier, which ensures the best gasification process, is individual for each chimney height. With a flue exceeding the above minimum values, the regulator can be closed more than 45 degrees from the longitudinal position. Only in this mode does the furnace have maximum efficiency and heat transfer, and only in this mode is its operation allowed.
REMEMBER: DO NOT OPERATE THE OVEN WITH THE GASIFICATOR FULLY OPEN!

With the power regulator, after the oven has heated the whole room, you can set the desired temperature by closing the regulator flap. It is not recommended to close the regulator completely.

In order to extinguish the furnace, it is necessary to set the regulator-gasifier in the longitudinal (open) position, put the power regulator in the vertical (closed) position - the furnace will slowly go out.

Fuel addition

Before opening the door of an oven already operating in gasification mode, ALWAYS OPEN BOTH DOORS FULLY AND WAIT 5-10 MINUTES.Only then open the door, add fuel, and then return the flaps to their original position.

Ash

Ash formation is negligible. It is not necessary to completely remove it from the furnace; on the contrary, YOU MUST MAKE SURE THAT THE LOWER PIPES IN THE THURNER ARE ALWAYS COVERED WITH ASH, which is necessary for normal gasification of the fuel.
DO NOT use the Breneran stove: heat the stove with flammable or flammable liquids; use liquid and gaseous fuels as fuel; use firewood, the length of which exceeds the dimensions of the furnace; dry clothes, shoes and other items on the parts of the oven; remove soot from the chimney by burning; remove ash and coals from an uncooled oven; operate the device in the kindling mode; operate the device with an open fire door; use the device installed in a manner not specified in this manual; pour water on the fire in the firebox; cover the stove with brick or stone.

Advantages and disadvantages of Breneran-type equipment

The main positive qualities of long-burning heating furnaces Buleryan include:

High efficiency of work. Up to 80% of the generated heat goes to heating and heating the fluid in the circuit.
Uniform heating. Thanks to the convection system of work, all parts of the room are warmed up.
Fuel economy. The device works on the principle of long burning, first the firebox heats up with an intense flame, then the temperature is only maintained: the wood smolders.
Simple installation. There is no need to carry out complex preparations: to mount the foundation, you just need to protect the walls and floor from heat.
Durability. Buleryan furnaces are made of heat-resistant materials, which significantly extends their service life.

This equipment also has several minor features:

The need to install a high chimney: at least 3 meters from the upper surface of the stove.
Condensation forms, which must be removed periodically to avoid unpleasant odors.
Considerable dimensions, which requires the allocation of a large amount of space for placing heating equipment.

Where to buy quality oven equipment?

To purchase Breneran heating stoves in Moscow, the region and regions of the Russian Federation, contact the specialists of our online store. We offer:

Prompt delivery throughout Russia. Sending to remote regions is carried out in 1-2 days after payment for the equipment.
Low prices. We work directly with suppliers, we exclude markups from intermediaries, which allows us to make the best offer on the market.
Warranty from 2 years.
Quality control and equipment compliance with domestic and foreign standards.

To buy a Buleryan stove or get advice, contact the company's managers by phone or leave a request for a call back.

The long-burning furnace manufacturer Breneran has an impressive track record in the manufacture of such equipment. These products are in great demand in the Russian market. The company gives a 2.5-year guarantee for the reliability and safety of its products.

The production company Laotherm has been present on the Russian market since 1993. Previously, it produced equipment under the Buleryan brand. Since 2005, the products have received a modern brand name - Breneran. Also, this company produces more budgetary models - Buran ovens. They are in no way inferior to their predecessor.

Furnaces Breneran manufactured by ZAO LAOTHERM, Moscow.

Furnace device Breneran for home, for summer cottages

1 - power regulator (blower);
2 - gasifier regulator;
3 - gasification combustion chamber;
4 - afterburner chamber;
5 - full gas combustion injectors;
6 - tee (chimney element)

What is a Breneran oven?

The Breneran stove is a convection air heater. Perfect for our winter.The Breneran ovens are distinguished by their extremely high efficiency - up to 80%. They work on almost all types of solid fuels: wood, wood waste, cardboard, peat briquettes, brown coal, etc. (except for coal). Due to the special design of the furnace, combustion occurs at a lower temperature compared to direct-flow furnaces. This ensures reliable and long-term operation.

The Breneran stove for heating a house is an all-welded steel structure, girded at the top and bottom with many pipes through which heated air is distributed throughout the room and quickly warms it up to the required temperature. For one hour of operation of the Breneran oven, the air temperature in the room rises, on average, 15-20 ° C. Using flexible foil ducts, it is possible to supply warm air to other rooms. The Breneran stove is very economical (only one or two furnace loads per day - it depends on the type of stove), easy to maintain, reliable and environmentally friendly.

High efficiency (80%) and high heat transfer are achieved due to combustion in the gas generation mode. This happens as follows: when wood is burned in the lower chamber, the gases released during combustion enter the upper chamber of the Breneran furnace, where they finally burn out thanks to special afterburner injectors.

The power regulator on the furnace door and the regulator-gasifier on the flue pipe of the Breneran furnace allow you to control the process of heat release and set the desired temperature and burning time. When firing up the Breneran stove, both controls are set to the horizontal position (maximum open). With this position of the regulators, the stove should work only for the time during which the cold air inside the chimney warms up and a stable draft appears (usually 10-15 minutes). After the fire has flared up, the main fuel is laid so as to fill the volume of the combustion chamber as much as possible (the afterburner always remains empty). The regulator-gasifier is covered by about 45 ° and the furnace switches to the gas generation mode. With the power regulator, after the whole room has warmed up, you can achieve the desired temperature in your room.

Ash formation in the Breneran kiln is negligible. It is not required to completely remove it - the lower part of the pipes must always be covered with ash, which is necessary for normal gasification.

Furnace sizes

Breneran stoves are available in six standard sizes, depending on the volume of heated rooms:

Basic technical data of Breneran heating stoves for home, for summer cottages:
AOT - 6 type 00	AOT - 8 type 05	AOT - 11 type 01	AOT - 14 type 02	AOT - 16 type 03	AOT - 19 type 04
Height (cm)	63	76	83	83	92	92
Width (cm)	42	56	57	57	68	68
Depth (cm)	60	61	76	90	114	148
Weight (kg)	50	65	95	120	180	250
Power, kWt)	6	8	11	18	27	35
Room volume (cubic meters)	100	140	200	400	600	1000
Combustion chamber capacity (l)	40	50	70	100	150	200
Chimney diameter (cm)	12	12	12	15	15	18
Furnace door diameter (cm)	27	27	27	27	38	38
Chimney height (m)	4	5	6	7	8	10

The Breneran furnaces of the AOT-6, AOT-8, AOT-11, AOT-14 models can be equipped with a furnace door with an insert made of SCHOTT ROBAX® heat-resistant glass. Through such a door, you can observe the combustion process:

The Breneran stoves of the AOT-6 (type 00) and AOT-8 (type 05) models are produced in the modification of the heating and cooking type with a stove for cooking.

AOT-6 is produced with 1-burner and 2-burner stove,
AOT-8 - with a 2-burner stove.

ZAO Laotherm has developed and patented the Breneran-AQUATEN oven, which has no analogues in the world. It runs exclusively on solid fuels: wood, cardboard, wood and peat briquettes.

The stove is a powerful liquid heater for a water heating system. It can be used to heat domestic and industrial premises with a volume of 200 to 1000 cubic meters. Thanks to its unique design, the furnace efficiency reaches 70%, and depending on the model, it works on one tab from 6 to 12 hours.

The “Breneran-AQUATEN” furnace is an all-welded steel structure covered with heat-resistant paint. So, in terms of appearance and material, it is fully consistent with its time. And you can install it in the boiler room or basement.

The unit itself consists of two combustion chambers: a lower one, a gasification chamber and an upper gas afterburner chamber. The stove is equipped with two regulators: a power regulator is mounted on the door, and a regulator-gasifier is mounted on the chimney at the rear of the stove.

Due to the fact that the pipes that form the furnace body are in the furnace by two thirds, the maximum heating of the coolant circulating through the pipes (batteries) occurs. The furnace is designed to operate in an open system, and the liquid is lifted by gravity.

Thanks to the injectors, which function as a kind of "afterburners", the maximum CO2 combustion is achieved.

To maintain a positive temperature in the system in winter (when it is not possible to ensure the operation of the device using solid fuel), an electric heating element with a capacity of 1 kW is provided. Subject to all the requirements of the instructions and fire safety, the manufacturer's warranty for the stove is 2.5 years.

Indicator name	AOTV-6/00	AOTV-11/01	AOTV-14/02	AOTV-16/03	AOTV-19/04
length, mm	700	900	1000	1300	1700
width, mm	535	700	700	800	800
height, mm	934	1300	1300	1400	1500
flue pipe diameter, mm	120	120	150	150	180
weight of the device, kg	86	150	250	320	350
room volume, cubic meters	100	200	400	600	1000
loading hole diameter, mm	286	286	286	340	340

Particular attention should be paid to the recommended chimney height of the Breneran stove, because with a shorter chimney, the stove will not work in the economical gasification mode !!!

An important point is the correct installation of the Breneran stove.

If you want to calculate the cost of the chimney, we recommend using the convenient and intuitive calculator of the TEPLODRIVE ONLINE STORE on the quick chimney calculation page. When calculating, take into account that the diameter of the pipe for the Breneran ovens is 120 mm and the thickness of the steel is from 0.5 mm to 1.0 mm.

Advantages of heating furnaces Buleryan (Breneran)

High ergonomic qualities.
Ease of use.
Safety when using and working with fuel materials.
Aesthetically pleasing appearance.
An excellent combination of cost and quality and technical characteristics.

The R-sauna company offers to buy a Buleryan stove at economical prices. The variety of assortment in different price categories is an excellent opportunity for the consumer to choose the optimal furnace equipment. There are also models equipped with a hob. Such devices are used not only for heating premises, but also for cooking - this is an excellent solution for country houses and premises without centralized utilities.

Our catalog contains gas generator and sauna models, equipment with a hob, solid fuel boilers for hot water heating, fireplaces, barbecues, barbecue ovens, as well as spare parts, accessories and add-ons for stove equipment.